Generic PAM Decoder

 

General description

The Generic PAM (Pulse Amplitude Modulation) decoder is a universal decoder for PAM transmissions. It decodes PAM signals from 10 baud to 2500 baud. In most cases it is used together with the SkySweeper bit analyzing tool, which provides the synchronizing and character display functions. The decoder frequency must be set either by double clicking the left mouse button or by using the automatic carrier search function. The blue bar in the decoder’s spectrum display indicates the frequency of the decoder.

 

SkySweeper supports both FFT and waterfall display modes for decoder tuning. The Decoder Spectrum Dialog chapter gives more information about spectrum display options.

 

Configuration

Pressing the ‘Config’ button opens the following Configuration dialog box.

 

 

 

 

Parameters

Tone Scan Area

The PAM transmission is scanned inside this area.

Pulse Length

The PAM tone length in milliseconds can be set here. If the mode is already known, the tone length is easy to set. If the pulse length is not known, it has to be analyzed for example by using PSA (PAM Speed Analyzer).

 

Baud Rate

The PAM baud rate can be set here.

 

Filter width

Bandwidth of PAM decoder internal filter.

 

Negative polarity

Inverts the output bits. As a default, the higher amplitude means bit ‘1’ and the lower bit ‘0’.

 

Print Format

The generic decoder print format can be changed by pressing the right mouse button over the text area window and selecting Properties from the pop-up menu. The Properties command opens the Bit Display Configuration Dialog

 

FFT

The FFT button opens and closes the power spectrum window. You can, for example, close the power spectrum window when the decoder has been locked onto the correct frequency in order to get more space for the text window.

 

Save

The Save button opens the log file control Dialog, which is used to open or close a log file. The detector text window can also be saved into a file or sent into a socket.

 

Lock

The Lock button locks or unlocks the decoder frequency. The decoders have the ‘automatic frequency tracking’ feature. Push the Lock button when you want to lock the decoder onto a selected frequency. Push the Unlock button when you want to release the frequency locking.

 

Reset

The ‘Reset’ button resets the decoder and clears the text window.