**************** 20-047 - finding COMMPORT - when first installing Scancat-Lite *******

The USB cable/device (20-047) "becomes" a serial port once it is proplerly installed,
This is the way software talks to the radio. IF you install the "Drivers" for the USB device,
it also sets up a NEW comm port on the computer. If you have it connected the right way,
when you plug in the USB the computer will find it.

Try this:

-Go to our Radio Selection menu.

(If you Are a Radio Shack Store)
Click on "If you are using 20-047 Cable" button

-Observe in the BLUISH box the comm ports we say you have.
-UNPLUG the USB adaptor.
-Wait about 20-30 seconds and then
    click the button "Check for Valid Comports"
-IF the USB has a serial port assigned,
   then ONE of the serial ports will "disappear"

-Plug back in the USB
-Wait 30 Seconds
-Wait about 20-30 seconds and then
    click the button "Check for Valid Comports"
-IF the USB has a serial port assigned,
    then ONE of the serial ports will "RE-appear"

That will be "the one".

CHECK the BOX "Using 20-047" cable. Then click on the correct commport

That should set all the radios for the same commport.

jim