Thanks Jim.  I kind of thought it would be easy.  I'll check the
freqs when I get a chance and see which one it is.  I will need to
monitor MED channel 82 (narrowband) during hurrcane recovery.  It is
on 463.1875 as designated by the FCC. As for the light, I wanted it
to come on only when it stops on a signal.  I'll have to see if I can
adjust it to only come on in the dim mode.  I have so much other crap
in my patrol Jeep that it lights up more than I want it to at night.
I never had the problem in the Crown Vic because everything was floor
level.

Thanks!
Gene

---- Original Message ----
From: scancat@scancat.com
To: genebrowder@cfi.net
Subject: Re: Scancat question by user
Date: Mon, 23 Jul 2007 08:35:15 -0500

>
>I think the problem is a frequency that the radio doesn't like. read
>these FAQs and that should help you figure out which one is "bad".
>
>http://www.scancat.com/FAQSource/RADIO_HANGS_UP_WHEN_SCANNING.htm
>
>                 and
>
>http://www.scancat.com/FAQSource/RADIO_HANGS_ON_ONE_OR_MORE_BANKS-PAR
>T-2.htm
>
>
>As to the Light. I'm not sure until I check this out. But I think it
>should work.
>
>Jim
>
>>Hi,
>>I finally got to use the scancat program this weekend to program my
>>R/S Pro2055 for my patrol car.  I retained the original programming
>>and just added my frequencies to bank 2.  When I bank scan after
>>programming the scanner works fine for banks 0-1 however when I turn
>>on bank 2 it seems to hang on the bank and is missing calls. I reset
>>and it scanned 0-2 sequentially about one or two times and hung up
>on
>>bank 2.  I turned bank 2 off and it worked fine.  So I deleted bank
>2
>>manually and the scanner worked fine. Have you ever seen this
>>problem?  It is almost as if it isn't seeing an end of file after
>the
>>20 frequencies I need to monitor.  I don't see how it can keep
>>scanning a blank channel but it acts as if its looking at all of the
>>channels.  Does the program do anything special when uploading the
>>bank file?  I am running a Presario computer with XP and the R/S
>>20-407 w/ USB interface.  I also noticed the light control does not
>>work with the 2055.  Any suggestions or answers?
>>
>>Thanks,
>>Gene Browder
>>Crestview, FL
>>
>>
>>
>>
>>--
>>No virus found in this incoming message.
>>Checked by AVG Free Edition.
>>Version: 7.5.476 / Virus Database: 269.10.12/910 - Release Date:
>>7/21/2007 3:52 PM
>
>
>Best regards
>
>Jim Springer
>____________________________
>Computer Aided Technologies
>  - http://www.scancat.com -
>Order Toll Free or Order On Line
>(USA Orders Only ) 1-888-722-6228
>(NON USA Orders  ) 1-318-687-4444
>(Tech Support    ) 1-318-687-2555
>(  Fax Line      ) 1-318-686-0449
>
>





--
No virus found in this incoming message.
Checked by AVG Free Edition.
Version: 7.5.476 / Virus Database: 269.10.14/912 - Release Date: 7/22/2007 7:02 PM